R - Round robin search backward, picking up from where last left off (highest to lowest). R - Round robin search forward, picking up from where last left off (lowest to highest). G - Search backward, dialing on first available channel in group (highest to lowest). G - Search forward, dialing on first available channel in group (lowest to highest). The following modifiers may be used before the channel number: If you need more than one enter them as Technology2/Resource2&Technolog圓/Resource3&.ĭAHDI allows several modifiers to be specified as part of the resource. Technology2/Resource2 - Optional extra devices to dial in parallel.These must be in the format of Technology/Resource, where Technology represents a particular channel driver, and Resource represents a resource available to that particular channel driver. Technology/Resource - Specification of the device(s) to dial.INVALIDARGS - Dial failed due to invalid syntax.ĭial(Technology/Resource&],]]]) Arguments.Will be set if the called party chooses to send the calling party to the 'torture' script. TORTURE - For the Privacy and Screening Modes.Will be set if the called party chooses to send the calling party to the 'Go Away' script. DONTCALL - For the Privacy and Screening Modes.CANCEL - Dial was cancelled before call was answered or reached some other terminating event.Any other result implicitly indicates the call was not answered. In this case, you can use DEVICE_STATUS to check if the endpoint is actually in use, if needed. Note that some SIP devices will respond with 486 Busy if their Do Not Disturb modes are active. BUSY - The called party was busy or indicated a busy status.NOANSWER - Called party did not answer.This can occur if there is a slow or no response from the remote end. CONGESTION - Channel or switching congestion occured when routing the call.endpoint is not registered, or an attempt was made to call a nonexistent location, e.g. CHANUNAVAIL - Either the dialed peer exists but is not currently reachable, e.g.DIALSTATUS - This is the status of the call.FORWARDERNAME - If a call forward occurred, the name of the forwarded channel.DIALEDPEERNUMBER - The number that was dialed for the answered outbound channel.DIALEDPEERNAME - The name of the outbound channel that answered the call.

PROGRESSTIME_MS - This is the milliseconds version of the PROGRESSTIME variable.

PROGRESSTIME - This is the time from creating the channel to the first PROGRESS event received.

RINGTIME_MS - This is the milliseconds version of the RINGTIME variable.

RINGTIME - This is the time from creating the channel to the first RINGING event received.

ANSWEREDTIME_MS - This is the milliseconds version of the ANSWEREDTIME variable.

ANSWEREDTIME - This is the amount of time for actual call.

DIALEDTIME_MS - This is the milliseconds version of the DIALEDTIME variable.

DIALEDTIME - This is the time from dialing a channel until when it is disconnected.

This application sets the following channel variables: Unlike OUTBOUND_GROUP, however, the variable will be unset after use. If the OUTBOUND_GROUP_ONCE variable is set, all peer channels created by this application will be put into that group (as in Set(GROUP()=.). If the OUTBOUND_GROUP variable is set, all peer channels created by this application will be put into that group (as in Set(GROUP()=.). This application will report normal termination if the originating channel hangs up, or if the call is bridged and either of the parties in the bridge ends the call. Dialplan execution will continue if no requested channels can be called, or if the timeout expires. Unless there is a timeout specified, the Dial application will wait indefinitely until one of the called channels answers, the user hangs up, or if all of the called channels are busy or unavailable. All other channels that were requested will then be hung up. These two channels will then be active in a bridged call. As soon as one of the requested channels answers, the originating channel will be answered, if it has not already been answered.

This application will place calls to one or more specified channels. Attempt to connect to another device or endpoint and bridge the call.

Macro autoanswer asterisk